Loading ...
Loading ...
Loading ...
9
PRIOR TO USE
1.
Clean your refrigerator thoroughly and wipe off all dust that
accumulated during shipping.
2.
Install accessories such as ice cube bin, drawers, shelves,
etc., in their proper places. They are packed together to
prevent possible damage during shipment.
3.
Allow your refrigerator to run for at least two to three
hours before putting food in it. Check the flow of cold air
in the freezer compartment to ensure proper cooling. Your
refrigerator is now ready for use.
INSTALLATION
The refrigerator should always be plugged into its own
individual properly grounded electrical outlet rated for 115
Volts
, 60 Hz, AC only, and fused at 15 or 20 amperes. This
provides the best performance and also prevents overloading
house wiring circuits which could cause a fire hazard from
overheated wires. It is recommended that a separate circuit
serving only this appliance be provided.
INSTALLATION
(continued)
1.
To avoid noise and vibration, the unit must be leveled and
installed on a solidly constructed floor. If required, adjust
the leveling legs to compensate for unevenness of the
floor. The front should be slightly higher than the rear to
aid in door closing. Leveling legs can be turned easily by
tipping the cabinet slightly. Turn the leveling legs to the left
to raise the unit or to the right to lower it. (See Leveling and
door Alignment.)
NOTE:
Installing on carpeting, soft tile surfaces, a platform
or weakly supported structure is not recommended.
2.
Install this appliance in an area where the temperature is
between 55°F (13°C) and 110°F (43°C). If the temperature
around the appliance is too low or high, cooling ability may
be adversely affected.
3.
Select a place where a water supply can be easily
connected for the automatic icemaker.
NOTE:
The water pressure must be from 30 to 125 psi
or 207-862 kPa or 2.1-8.8 kgf/cm
2
.
If the refrigerator is
installed in an area with low water pressure below 30 psi,
you can install a booster pump to compensate for the low
pressure.
4.
For sufficient door opening clearance, allow at least 4
inches between the side of the refrigerator and an adjacent
wall or surface that extends fully to or past the front door of
the refrigerator
. For complete door opening, allow at least
14.8 inches between the side of refrigerator and a wall or
surface that extends to or past refrigerator front door.
5.
Too small of a distance from adjacent surfaces may result
in lowered freezing capability and increased electricity
consumption charges. Provide the following unobstructed
clearance for sufficient air flow around the refrigerator:
-At least 2 inches between refrigerator back and wall.
-At least 2 inches between refrigerator top and overhead
surface.
Shock Hazard:
To reduce the risk of electric shock, do not install the
refrigerator in a wet or damp area.
Loading ...
Loading ...
Loading ...