Loading ...
Loading ...
Loading ...
6 feet
6 feet
Place the Wirk
TM
Ride Workstation in the area where it will be used. It is recommended that the Wirk
TM
Ride Workstation be placed on an equipment mat. The maximum operation dimensions of the Wirk
TM
Ride Workstation are approximately 51.4 inches long x 50.4 inches wide x 61.2 inches tall. (These
dimensions may vary up to one inch.) An area 6 feet wide x 6 feet long is required for safe operation of
the Wirk
TM
Ride Workstation. Make sure that adequate space is available for access to and passage
around the Wirk
TM
Ride Workstation.
LEVELING: Adjust the LEVELING CAPS(31) on the REAR STABILIZER(10) so that the Wirk
TM
Ride
Workstation sits on the oor without rocking.
MOVING: The Wirk
TM
Ride Workstation has a pair of WHEELS(32) on the REAR STABILIZER(10).
Adjust the RESISTANCE ARMS(35, 66) to the upright position. Hold the RESISTANCE
ARMS(35, 66) and tilt back on WHEELS(32) to move the Wirk
TM
Ride Workstation.
FUNCTION INSPECTION:
Visually inspect the Wirk
TM
Ride Workstation to verify that assembly is as shown in the above
illustration. Check the function of the Wirk
TM
Ride Workstation by turning the crank slowly through one
complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(57) and
verify that it functions properly and the resistance changes.
CAUTION: Locate and read the CAUTION LABEL(103) on the WirkTM Ride Workstation. Make sure
that all users read the CAUTION LABEL(103) before using the product.
SET UP INSTRUCTIONS
13
Equipment Mat
(not included)
Loading ...
Loading ...
Loading ...