1 3
4
2
5 6
Contents:
VDOMUS Acrylic Cupcake Display Stand Installation Instruction
Installation instruction:
Step 1. As shown in Figure 1, take out the largest acrylic plate, the
side with a larger diameter hole in the middle should be on the
bottom, so as to install the one-way screw, then stick the rubber
feet on the bottom four corners to avoid slippery
Step 4. As shown in Figure 4, repeat step 3 to install the remaining
two central rods and the third plate
Step 5. As shown in Figure 5, take out the smallest acrylic plate,
the side with a larger diameter hole in the middle should be on the
top, so as to install the one-way screw, please tighten the screw
with a screwdriver
VDOMUS GUARANTEE:
VDOMUS provides 12 months' guarantee and 24 hours customer service. If you have any problems or suggestions, please be free to contact us at v[email protected]om, we will give you
a friendly and easy-to-reach support.
Step 6. As shown in Figure 6, we have a string light as a gift for
you, and there are some holes on the plates, you can optionally
twine the sting lights on this stand to your own liking
Step 2. As shown in Figure 2, take one central rod and a one-way
screw to build the first stand, please tighten the screw with a
screwdriver
Step 3. As shown in Figure 3, place one end of the two-way screw
into the central rod and tighten it, then take out the second
largest plate and let the middle hole through the screw
Acrylic Plate
x 4
Central Rod
x 3
One-way Screw
x 2
Two-way Screw
x 2
Rubber Feet
x 4
Screwdriver
x 1