Loading ...
Loading ...
Loading ...
Lay REAR FENCE GUIDE BAR on table to act as a
straightedge. If outer edge of extension is higher or lower
than table surface;
A, Slightly loosen nuts holding bracket to extension
using 7/16 in. wrench,
B, Move end of extension up or down until outer edge
is even with table surface .... check with GUIDE
BAR , ,, tighten nuts.
C Recheck INNER edge of extension to make sure it
has not moved .... readjust, if necessary,
INSTALLING RIP FENCE GUIDE BARS
I,. From among the loose parts find the following
hardware:
2 Hex Head Screws, 5/16-t8 x 1-3/4 in long
2Hex Head Screws, 5!16-18x 1 in long
4 Hex., Nuts, 5/16-18 (approx dia of hole 5/16 in )
4 External Lockwashers, 5/16 in (approx. dia, of hole
5/16 in,)
2 Spacers, 3/4 in. diao x 1/2 in. long
2 Self-threading nuts
2, Lay guide bars on table,
NOTE: The various holes in the bars allow them to be
repositioned on the saw and also makes them adaptable
to other models,
3., Insert 1-3/4 in. long screw through the FIRST hole
from the LEFT IN THE FRONT BAR . _ _ insert
another 1-3/4in long screw through LARGE hole at 4_
EXTREME LEFT SIDE OF SWITCH BRACKETthed
through SIXTH hole in bar Hold them in place with a
piece of masking tape from the underside
Place spacers on screws,
5.
Insert bolts through holes in middle and on right side of
front of saw table ..o install lockwashers and nuts
DON'T SCREW NUTS ON ALL THE WAY, just get
them started on the screws.
6
7.
8,
Remove the 3 screws from rear of table extension.
Insert I in,, long screws in FIRST and THIRD holes of
rear bar and attach to table the same way
Insert ends of FENCE GUIDE BAR ROD through
round holes at outer end of bars.
NOTE: The ends of the ROD are not threaded ... the
SELF THREADING NUTS will cut threads on the rod
as they are screwed om
[ ====e_e=:=
Loading ...
Loading ...
Loading ...