Loading ...
Loading ...
Loading ...
ASSEMBLY
ATTACHING LEGS
1, Turn the saw upside down
NOTE: DO NOT LAY IT ON THE FLOOR AS THIS
MAY SCRATCH THE TABLE SURFACE. PLACE IT
ON STRIPS OF WOOD OR PARTS OF THE PACKING
MATERIAL,,
2_ From among the loose parts, find the following
hardware:
16 Hex, Head Screws, 5/16-18 x 5/8 in, long
16 Hex. Nuts, 5/16-18 (approx dia of hole, 5/16 in.,)
16 Hex, Head Screws, 1/4 ira-20 x t/2 in. long
16Hex Nuts, 1/4-20(approx, dia.ofhoie, 1/4 in)
8 Hex.. Nuts, 1/2-13 (approx dia of hole, 1/2 in.)
4 Leveling Feet
16 Lockwashers, 1/4 in. External Type (approx, dia of
hole, I/4 in.)
I6 Lockwashers, 5/16 in. External Type (approx dia
of hole, 5/16 in.)
NOTE: The four stiffeners are identical BE SURE TO
ATTACH THE SIDE STIFFENERS USING THE
OUTER HOLES .... ATTACH END STIFFENERS
USING INNER HOLES..
3. Insert screws through legs then through stiffeners
Install Iockwashers and nuts. DO NOT TIGHTEN
4. After at1 screws, washers and nuts are installed, tighten
all nuts_
5o install leveling feet..
6,. Place saw in upright position,.
5/!6 -18 Ă—
LEG
END STIFFENER
SIDE STIFFENER
END STIFFENER
SIDE STIFFENER
INNER
END
HOLES HOLES
BEFORE PROCEEDING WITH THE ASSEMBLY, THE
TABLE 1NSERT, BLADE SQUARENESS, AND BLADE
PARALLELISM MUST BE CHECKED AT THIS TIME,
CHECKING TABLE INSERT
Insert should be flush with table top, Check as shown
Loosen flat head screw that holds insert and adjust the
four set screws as necessary,, Tighten flat head screw,
Do not tighten screw to the point where it deflects the
insert
3/32 iN
SETSCREW WRENCH
TABLE INSERT j
FLAT HEAD _ _ ._
2. To remove insert
A) Loosen Screw
B) Lift insert from front end, and purl toward front of
saw.
3_ To replace insert°
Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert wif] drop over screw, Tighten screw.
Do not tighten screw to the point where it wifl deflect
the insert.
Loading ...
Loading ...
Loading ...