Craftsman 113242502 12" motorized table saw

User Manual - Page 10

For 113242502.

PDF File Manual, 40 pages, Download pdf file

Loading ...
Loading ...
Loading ...
9. Holdrodwithonehandandwitha1/2in. wrench or
pliers start screwing on ONE of the nuts only A TURN
OR TWO .... screw on other nut the same way
10_ Using TWO 1/2 in,, wrenches or pliers tighten both of
the nuts,
IMPORTANT: Apply a coat of paste wax to the top surface
and front edge of the front guide bar, This will allow the
fence to slide more easily,
11o Slide the bars so that screws are in the MIDDLE of the
slotted ho_eso
12. Position rip fence over miter gauge groove, holding up
the rear end while engaging front end with bar o..
lower fence onto tableĀ°
!3,, Raise blade all the way up.
14. Carefully move fence against blade.
15, Move front bar until "0" mark on rip scale is
approximately in line with indicatorĀ°
16. Move FRONT bar upwards until fence is approximately
1/32 in,, above table .... tighten screw at left end of
bar_,
NOTE: Fold a piece of newspaper making 8 thicknesses
and place between rip fence and table to act as a spacer.
This will hold the fence off of the table approx. 1/32
in,
17,, Adjust rear bar so that the fence is approximately 1/32
in, above table make sure it is square with fence guide
bar rod .. , tighten screw at end of bar.
18,, Replace screws in rear of table extension .... be sure
top surface of extension is PARALLEL to top surface
of rear guide bar,,
8 THICKNESSES
OF PAPER
19_ Move fence to RIGHT edge of table .... make sure it is
approxo 1/32 in. above table at front and rear and
tighten screws.
8 THICKNESSES
OF PAPER
Io
Loading ...
Loading ...
Loading ...