Loading ...
Loading ...
Loading ...
CHECKING BLADE SQUARENESS TO TABLE
I, Loosen ELEVATION LOCK by pulling KNOB forward,
2. Turn ELEVATION handwheel clockwise until blade is
as high up as it will go,
IMPORTANT: BLADE must be SQUARE (90 ° ) to
TABLE, in order to ALIGN rip fence,
3, Check for BLADE SQUARENESS .... if blade is not
square to table, adjust it at this time,,
NOTE: The combination square must be "true" - see
start of "Unpacking and Checking Contents" section on
page 6 for checking method
Refer to "BLADE TILT, OR SQUARENESS OF BLADE
TO TABLE" adjustments on page 24
MAKE SURE SQUARE
IS NOT TOUCHING
TiP OF TOOTH
TILT CLAMP KNOB
ELEVATION
HANDWHEEL
-....
TILT CRANK
ELEVATION LOCK KNOB
SAWBLADE PARALLELISM
The sawblade must be parallel to the miter gauge slots and
the rip fence in order to prevent heeling To check for
parallelism:
I Raise blade all the way up
2. Mark an "x" on one of the teeth which is SET (bent) to
the LEFT.
3, Place the head of a combination square in the
GROOVE .... adjust blade of square so that it just
touches the tip of the MARKED tooth
4, Move square to REAR, rotate biade to see if MARKED
tooth again touches blade of square,
5, If tooth touches square the same amount at FRONT
and REAR .... sawblade is PARALLEL to MITER
GAUGE GROOVE
If tooth does not touch front and rear, adjust immediately
MARK *'X" ON TOOTH
according to instructions on pg. 23 under heading:
"HEELING ADJUSTMENT: PARALLELISM OF
SAWBLADE TO MITER GAUGE GROOVE"
ATTACHING AND ASSEMBLING TABLE EXTENSIONS
1, From among the loose parts find the following
hardware,
4 Corner Support Brackets
4 Corner Stiffener Brackets
16 Truss Hd Screws 1/4-20 x 1
16 Ext, Lockwashers I/4
16 Hex Nut 1/4-20
B Hex Hd, Screws 5/16-18 x 1-1/4
8 Ext° Lockwasher 5/16
8 Hex Nut 5/16-18
B FlatWasher 11/32
Assemble brackets with hardware listed above as shown,
Insert 5/16-18 x t-1/4 in. long screws through holes in
EXTENSION then through table° tnstarl flat washer,
lockwashers and screw on the nuts .... DO NOT
TIGHTEN,
Align front edge of extension with front edge of saw table_
Pull Extension UPWARDS above table surface ....
SLIGHTLY TIGHTEN SCREWS using !/2 in, wrench.,
Using smal! block of hardwood and hammer, tap extension
DOWNWARDS at front, center & rear, until it is EVEN
with table surface , , TIGHTEN SCREWS.
BLOCKOF
\
/
f
Loading ...
Loading ...
Loading ...