Loading ...
Loading ...
Loading ...
1. NEVERUSETHERIPFENCEASA LENGTHSTOP
BECAUSETHECUTOFFPIECECOULDBIND
BETWEENTHEFENCEANDTHEBLADECAUSING
AKICKBACK.
2. Whenmakingrepetitivecutsshorterthan6in,,,clampa
blockofwood2in longtothetabletoactasalength
stopDonotclampdirectlytothebottomedgeofthe
tablebecausethe"swivel"of theclampwillnotgrip
properly.Placea smallblockof woodbetweenthe
bottomedgeofthetableandthe"'C" clamp
CAUTION: When clamping the block, make sure that
the end of the block is well in front of the sawbladeo Be
sure it is clam_ed securely,
3, Slide the workpiece along the miter gauge until it
touches the block , hold it securely or clamp it with
the Hold-Down Clamp (Optional Accessory)
4 Make the cut , pu_t the workpiece back ,. , push the
cut off piece off the table with a long push stick ..... DO
NOT ATTEMPT TO PICK IT UP AS THIS COULD
ENDANGER YOUR HANDS,
BLOCK
MITER CUTTING
MITER CUTTING is known as cutting wood at an angle
other than 90 ° with the edge of the wood Follow the same
procedure as you would for crosscutting.,
Adjust the miter gauge to the desired angle, and lock it,
The miter gauge may be used in either of the grooves in the
table,,
When using the miter gauge in the LEFT Hand groove, hold
the workpiece firmly against the miter gauge head with
your left hand, and grip the lock knob with your right
When using the RIGHT hand groove, hold the workpiece
with your right hand and the lockknob with your left hand,
Use the Hold-Down Clamp (Optional Accessory} on the
miter gauge for greater accuracy,,
PIEC_
BEVEL CROSSCUTTING
BEVEL CROSSCUTTING is the same as crosscutting
except that the wood is also cut at an angle , , other than
90 ° with the flat side of the wood
Adjust the blade to the desired angle,.
Use the Miter Gauge in the groove to the RIGHT of the
blade, it cannot be used in the groove to the LEFT because
the blade guard wi!t interfere Hold the workpiece with
your right hand and the Iockknob with your left hand
Use the AUXILIARY FENCE/WORK SUPPORT for
additlona] support of the workpiece
Lay it across the guide bars to support the workpiece as
near to the end as possible
Use the Hold-Down Clamp (Optional Accessory} on the
miter gauge for greater accuracy
COMPOUND MITER CUTTING
COMPOUND MITER CUTTING is a combination of miter
cutting and bevel crosscutting The cut is made at an angle
other than 90 ° to both the edge and the flat side of the
wood_
Adjust the miter gauge and the blade to the desired angle
Make sure miter gauge is locked,
: ///
i ////
19
Loading ...
Loading ...
Loading ...