Loading ...
Loading ...
Loading ...
External device control
The HEOS Drive can tightly integrate with most Denon AV receiver to
allow them to operate as if they were one device.
You can configure your HEOS Drive to tell the connected device when to
turn on, turn off, select the correct input and adjust volume and mute.
You can adjust specific settings for each of your HEOS Drive in your
system:
1
Select the Settings a icon located in the upper left
corner of the main “Music” menu to display the
Settings menu.
2
Select “My Devices” to display a list of your devices.
3
Select a HEOS Drive.
4
Select the Zone you want to set.
5
Select “Control”.
6
Select the method which is most appropriate for your
configuration:
o
IP Control
IP Control is available for Denon AV receiver models sold after 2010
which are connected to the same network as the HEOS Drive and
Controller devices.
1
Select IP.
2
Select the AV receiver that you have your HEOS Drive
is connected to.
3
Select the input on the AV receiver that you have your
HEOS Drive connected to.
4
Select Done.
NOTE
0
You can test the connection to the AV receiver by pressing the power on, off, and
input buttons.
0
The following settings are forced to change when IP Control is set.
0
Line Out Level: Fixed
0
High Pass Filter: Off
0
Subwoofer: Off
Contents Setup Use Troubleshooting Status LED Appendix
48
Loading ...
Loading ...
Loading ...