Loading ...
Loading ...
Loading ...
UNPACKING
Thisproductrequiresassembly.
[] Carefullyliftsawfromthe cartonbythecarryinghandle
andthesawbase,andplaceit ona levelworksurface.
NOTE:Thissawisheavy.Toavoidbackinjury,liftwith
yourlegs,notyourback,andgethelpwhenneeded.
[] Thissawhasbeenshippedwiththesawarmsecured
inthedownposition.Toreleasethesawarm,push
downonthetopofthesawarm,cutthetie-wrap,and
pulloutonthelockpin.
[] Liftthesawarmbythe handle.Handpressureshould
remainonthesawarmto preventsuddenriseupon
releaseofthetie wrap.
[] Inspectthetoolcarefullyto makesurenobreakageor
damageoccurredduringshipping.
[] Donotdiscardthepackingmaterialuntilyouhave
carefullyinspectedandsatisfactorilyoperatedthetool.
[] Thesawisfactorysetforaccuratecutting.After
assemblingit, checkforaccuracy.If shippinghas
influencedthesettings,referto specificprocedures
explainedinthismanual.
Ifanypartsaredamagedor missing,pleasecall
1-800-932-3188forassistance.
[]
A
WARNING: If any parts are damaged or missing
do not operate this tool until the parts are replaced.
Failure to heed this warning could result in serious
personal injury.
WARNING: Do not attempt to modify this tool
or create accessories not recommended for use
with this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
A
A
WARNING: Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
WARNING: Do not start the miter saw without
checking for interference between the saw blade and
the sliding miter fences. Damage could result to the
blade if it strikes the miter fence during operation of
the saw.
WARNING: Always make sure the compound miter
saw is securely mounted to a workbench. Failure
to heed this warning can result in serious personal
injury.
MOUNTING HOLES
See Figure 7.
The compound miter saw should be permanently mount-
ed to a firm supporting surface such as a workbench.
Four bolt holes have been provided in the saw base for
this purpose. Each of the four mounting holes should be
bolted securely using 3/8 in. machine bolts, lock washers,
and hex nuts (not included). Bolts should be of sufficient
length to accommodate the saw base, lock washers, hex
nuts, and the thickness of the workbench. Tighten all four
bolts or screws securely. Do not use screws if mounting to
a leg stand.
The hole pattern for mounting to a workbench is shown in
figure 7. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
TRACEHOLES
ATTHESELOCATIONSFOR
HOLEPATTERN
BASE
14
TRACEHOLES
ATTHESELOCATIONSFOR
HOLEPATTERN
MOUNTINGSURFACE
Fig. 7
Loading ...
Loading ...
Loading ...