hOmeLabs HME030357N User Manual

Loading ...

Step2:Installthedrainjoint(Heatpump

unit only)

Before bolting the outdoor unit in place, you must

install the drain joint at the bottom of the unit.

Note that there are two different types of drain

joints depending on the type of outdoor unit.

If the drain joint comes with a rubber seal (see

Fig.A),takethefollowingsteps:

1. Fit the rubber seal on the end of the drain

joint that will connect to the outdoor unit.

2. Insert the drain joint into the hole in the base

pan of the unit.

3. Rotate the drain joint 90° until it clicks in

place facing the front of the unit.

4. Connect a drain hose extension (not included)

to the drain joint to redirect water from the

unit during heating mode.

If the drain joint doesn’t come with a rubber seal

(see Fig. B),takethefollowingsteps:

1. Insert the drain joint into the hole in the base

pan of the unit. The drain joint will click in

place.

2. Connect a drain hose extension (not included)

to the drain joint to redirect water from the

unit during heating mode.

Seal

Drain joint

(A) (B)

Base pan hole of

outdoor unit

Seal

IN COLD CLIMATES

In cold climates, make sure that the drain hose

is as vertical as possible to ensure swift water

drainage.Ifwaterdrainstooslowly,itcanfreezein

thehoseandﬂoodtheunit.

Step 3: Anchor outdoor unit

The outdoor unit can be anchored to the ground or

to a wall-mounted bracket with bolt (M10). Prepare

the installation base of the unit according to the

dimensions below.

UNIT MOUNTING DIMENSIONS

Thefollowingisalistofdifferentoutdoorunitsizes

and the distance between their mounting feet.

Prepare the installation base of the unit according

to the dimensions below.

Air inlet

Installation

Loading ...

hOmeLabs HME030357N Split Type Inverter Air Conditioners

User Manual - Page 36