Loading ...
Loading ...
Loading ...
Unied Access Point Administrator’s Guide
Unied Access Point Administrator’s Guide
Page 18
October 2017
Section 2 - Getting Started
(Access Point Name)# prompt.
4.) At the login prompt, enter
get management.
Information similar to the following prints to the screen.
Figure 4 - Command Line Interface (CLI) Connection
Conguring the Ethernet Settings
The default Ethernet settings, which include DHCP and VLAN information, might not work for all networks.
By default, the DHCP client on the UAP automatically broadcasts requests for network information. If you want to
use a static IP address, you must disable the DHCP client and manually congure the IP address and other network
information.
The management VLAN is VLAN 1 by default. This VLAN is also the default untagged VLAN. If you already have
a management VLAN congured on your network with a different VLAN ID, you must change the VLAN ID of the
management VLAN on the access point.
For information about using the Web interface to congure the Ethernet settings, see
“Ethernet Settings” on page
36. You can also use the CLI to congure the Ethernet settings, which the following section describes.
Using the CLI to Congure Ethernet Settings
Use the commands shown in the following table to view and set values for the Ethernet (wired) interface. For more
information about each setting, see the description for the eld in the following table.
Action Commands
Get the DNS Name
get host id
Set the DNS Name
set host id <host_name>
For example:
set host id lab-ap
Get Current Settings for the Ethernet (Wired) Internal
Interface
get management
Set the management VLAN ID
set management vlan-id <1-4094>
View untagged VLAN information
get untagged-vlan
Enable the untagged VLAN
set untagged-vlan status up
Disable the untagged VLAN
set untagged-vlan status down
Loading ...
Loading ...
Loading ...