Loading ...
Loading ...
Loading ...
Tool Air Fitting
This tool uses a free-flow connecting plug 1/4″ N.P.T. The inside diameter should be .200″ (5 mm) or larger. The
fitting must be capable of discharging tool air pressure when disconnected from the air supply.
Operating Pressure
60 to 100 p.s.i.g. (4.92 to 6.9 kg/cm²). Select the operating pressure within this range for the best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
Adjustments and Usage Prep
Air Supply and Connections WARNING: Do not use oxygen, combustible gases, or bottled gases as a power
source for this tool as a tool may explode, possibly causing injury.
Fittings
Install a male fitting on the tool that is free flowing and which will release air pressure from the tool when
disconnected from the supply source.
Hoses
Air hoses should have a minimum of 150 p.s.i.g. (10.6 kg/ cm²) working pressure rating or 150% of the maximum
pressure that could be produced in the air system. The supply hose should contain a fitting that will provide “quick
disconnecting” from the 1/4″ male fitting 3 on the tool.
Supply Source
Use only clean regulated compressed air as a power source for this tool.
NEVER USE OXYGEN, COMBUSTIBLE GASES, OR BOTTLED GASES, AS A POWER SOURCE FOR THIS
TOOL AS TOOL MAY EXPLODE.
Regulator
A pressure regulator with an operating pressure of 0–125 p.s.i.g. (0–8.79 kg/cm²) is required to control the
operating pressure for safe operation of this tool. Do not connect this tool to air pressure which can potentially
Loading ...
Loading ...
Loading ...