Loading ...
Loading ...
Loading ...
Insert nails into the track of magazine
Press pusher release 4 to disengage the follower
Sequential Trip Operation
This tool is supplied with a sequential trip trigger installed. The SEQUENTIAL TRIP contains a contact trip that
operates in conjunction with the trigger to drive a fastener. To operate a sequential trip tool, first position the
contact trip on the work surface
WITHOUT PULLING THE TRIGGER.
Depress the contact trip and then pull the trigger to drive a fastener. As long as the contact trip is contacting the
work and is held depressed, the tool will drive a fastener each time the trigger is depressed. If the contact trip is
allowed to leave the work surface, the sequence described above must be repeated to drive another fastener.
Tool Operation Check
CAUTION: Remove all fasteners from tool before performing tool operation check.
Press the contact trip against the work surface, without touching the trigger. THE TOOL MUST NOT CYCLE.
Hold the tool off the work surface and pull the trigger. THE TOOL MUST NOT CYCLE. Release the trigger. The
Loading ...
Loading ...
Loading ...