Loading ...
Loading ...
Loading ...
When working close to an edge of a workpiece or at steep angles use care to minimize chipping, splitting or
splintering, or free flight or ricochet of fasteners, which may cause injury.
Do not drive fasteners on top of other fasteners or with the tool at an overly steep angle as this may cause
deflection of fasteners which could cause injury.
Do not load the tool with fasteners when any one of the operating controls is activated.
Use extra caution when driving fasteners into existing walls or other blind areas to prevent contact with hidden
objects or persons on the other side (e.g., wires, pipes.)
The operator must not pull the trigger except during fastening operation as serious injury could result if the tool
accidentally contacts someone or something, causing the tool to cycle.
Keep hands and body away from the discharge area of the tool. The tool may bounce from the recoil of driving
a fastener and an unwanted second fastener may be driven possibly causing injury.
Check the operation of the trigger mechanism frequently. Do not use the tool if the trigger is not working
correctly as accidental driving of a fastener may result. Do not interfere with the proper operation of the trigger
mechanism.
Never inadvertently pull or grasp the trigger when moving about, changing work location, holstering or hanging
tools, or preparing work surfaces for fastening operation.
This tool produces SPARKS during operation. NEVER use the tool near flammable substances, gases, or vapors
including lacquer, paint, benzine, thinner, gasoline, adhesives, mastics, glues or any other material that is ‑‑ or the
vapors, fumes or byproducts of which are ‑‑ flammable, combustible or explosive. Using the fastenerer in any
such environment could cause an EXPLOSION resulting in personal injury or death to the user and bystanders.
WARNING: After driving a fastener, the tool may bounce back (“recoil”) causing it to move away from the work
surface. To reduce the risk of injury always manage recoil by:
Always maintain control of the tool.
Allowing recoil to move the tool away from the work surface.
Not resisting recoil such that the tool will be forced back into the work surface.
In “Contact Actuation Mode,” if workpiece contact is allowed to re-contact the work surface before the trigger is
released, an unintended discharge of a fastener will occur.
Keeping face and body parts away from the tool.
WARNING:
Disconnect tool
When not in use,
When performing any maintenance or repairs,
When clearing a jam,
When elevating, lowering, or otherwise moving tool to a new location,
When the tool is outside of the operator’s supervision or control,
When removing fasteners from the magazine. WARNING: When maintaining the tool:
Always shut off the air supply, and disconnect tool from the air supply when not in use.
When working on air tools note the warnings in this manual and use extra care when evaluating problem tools.
Additional Safety Warnings
Loading ...
Loading ...
Loading ...