Loading ...
Loading ...
Loading ...
Use the pneumatic tool only for the purpose for which it was designed.
Never use this tool in a manner that could cause a fastener to be directed toward the user or others in the work
area.
Do not use the tool as a hammer.
Always carry the tool by the handle. Never carry the tool by the air hose.
Do not alter or modify this tool from the original design or function.
Always be aware that misuse and improper handling of this tool can cause injury to yourself and others.
Never clamp or tape the trigger or contact trip in an actuated position.
Never leave a tool unattended with the air hose attached.
MAINTENANCE WARNING:
To reduce the risk of serious personal injury, turn the unit off and remove the air supply before making any
adjustments or removing/installing attachments or accessories.
An accidental actuation can cause injury.
When working on air tools, note the warnings in this manual and use extra care evaluating problem tools.
WARNING: Pusher spring (constant force spring).
Caution must be used when working with the spring assembly.
The spring is wrapped around, but not attached to a roller.
If the spring is extended beyond its length, the end will come off the roller and the spring will roll up with a snap,
with a chance of pinching your hand.
Also, the edges of the spring are very thin and could cut. Care must also be taken to ensure no permanent
kinks are put in the spring as this will reduce the spring’s force.
Assembly Procedure For Seals
When repairing a tool, make sure the internal parts are clean and lubricated. Coat each “O”-ring with lubrication
before assembling. Use a small amount of oil on all moving surfaces and pivots. After reassembly add a few drops
of Air Tool Lubricant through the air line fitting before testing.
Air Supply-Pressure And Volume
Air volume is as important as air pressure. The air volume supplied to the tool may be inadequate because of
undersized fittings and hoses, or from the effects of dirt and water in the system. Restricted air flow will prevent
the tool from receiving an adequate volume of air, even though the pressure reading is high. The results will be a
slow operation, misfeeds or reduced driving power. Before evaluating tool problems for these symptoms, trace the
air supply from the tool to the supply source for restrictive connectors, swivel fittings, low points containing water,
and anything else that would prevent the full volume flow of air to the tool
Accessories WARNING:
Since accessories, other than those offered by CRAFTSMAN, have not been tested with this product, the use of
such accessories with this tool could be hazardous. To reduce the risk of injury, only CRAFTSMAN-recommended
accessories should be used with this product. Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you need assistance in locating any accessory,
please contact CRAFTSMAN, or call 1-888-331-4569. Versatrack™ (Fig. K) WARNING: To reduce the risk of
serious personal injury, turn the unit off and remove the air supply before making any adjustments or
removing/installing attachments or accessories. An accidental actuation can cause injury.
WARNING: To reduce the risk of serious personal injury, do not use a damaged Versatrack™ hang hook or
Versatrack™ Trackwall. A damaged Versatrack™ hang hook or Versatrack™ Trackwall will not support the weight
Loading ...
Loading ...
Loading ...