Loading ...
Loading ...
Loading ...
trigger must return to the trigger stop on the frame.
Pull the trigger and press the contact trip against the work surface. THE TOOL MUST NOT CYCLE.
With your finger off the trigger, press the contact trip against the work surface. Pull the trigger. THE TOOL
MUST CYCLE.
Depth Adjustment
WARNING: To reduce the risk of serious personal injury, turn the unit off and remove the air supply before making
any adjustments or removing/installing attachments or accessories. An accidental actuation can cause injury.
The depth that the fastener is driven can be adjusted using the depth adjustment wheel.
To drive the fastener shallower, rotate the depth adjustment wheel 7 to the right.
To drive a fastener deeper, rotate the depth adjustment wheel 7 to the left.
Cold Weather Operation
WARNING: To reduce the risk of serious personal injury, turn the unit off and remove the air supply before making
any adjustments or removing/installing attachments or accessories. An accidental actuation can cause injury.
WARNING: Do not store tools in a cold weather environment to prevent frost or ice formation on the tool’s
operating valves and mechanisms that could cause tool failure.
WARNING: Some commercial airline drying liquids are harmful to “O”-rings and seals – do not use these low-
temperature air dryers without checking compatibility.
When operating tools at temperatures below freezing:
Make sure compressor tanks have been properly drained prior to use.
Keep the tool as warm as possible prior to use.
Make certain all fasteners have been removed from a magazine.
Lower air pressure to 80 p.s.i.g. or less.
Reconnect air and load fasteners into the magazine.
Actuate the tool 5 or 6 times into scrap lumber to lubricate o-rings.
Turn the pressure up to operating level (not to exceed 120 p.s.i.g.) and use the tool as normal.
Always drain the compressor tanks at least once a day.
In Addition to the Other Warnings Contained in this Manual Observe the Following for Safe Operation
Loading ...
Loading ...
Loading ...