Loading ...
Loading ...
Loading ...
ADJUSTING RIP SCALE INDICATOR
1. Turn ELEVATION handwheel clockwise until blade is
2.
3.
I NDI CATOR
up as high as it will go.
IMPORTANT: BLADE must be SQUARE (90 ° ) to
TABLE, in order to ALIGN rip fence.
Position fence on right side of sawblade so that it
touches the sides of the teeth.., tighten lock knob.
Loosen screw holding the indicator.., adjust indicator
so that it points to "2"... tighten screw.
NOTE: If you cannot adjust indicator so that it points
to "2", loosen the screws holding the front guide bar
and move the guide bar.
INSTALLING BLADE GUARD
1. From among the loose parts, find the hardware as
shown.
LOCK KNOB
\\
\
SQUARE NUT /_:_j_/SPREADER SUPPORT
'_'_'+ _ SPREADERBRACKET
SOCKET HEAD SPREADERCLAMP
SETSCREW
7/8 IN. LONG
" W,NS SCREW
17/64 IN. HOLE
HEX NUT ---'-"_
2. MAKE SURE THE BLADE IS ALL THE WAY UP
AND SQUARE WITH THE TABLE.
3. Position SPREADER SUPPORT on rod until it is even
with the end of the rod.
LOCKWASHER
EXT. 1/4 iN.
4.
Assemble the 7/8 in. long setscrews, nuts, Iockwashers
and washers to the SPREADER SUPPORT BRACKET
and slip the nuts into the slot in the spreader support.
5. Finger tighten ONLY THE HEX NUTS.
13
SQUARE NUT
SPREADER I
BRACKET |
.. _[-_
HEAD ",d.I I
SETSCREW I
FLAT
WASHER _
LOCKWASHER
HEX NUT _(_
Loading ...
Loading ...
Loading ...