Loading ...
Loading ...
Loading ...
14
Wire Entrapment Protection Devices
There are three options for wiring external entrapment protection devices depending on the specific device and how the device will function. Refer to the
manual included with your entrapment protection device for more information. These entrapment protection device inputs are for monitored devices,
which include pulsed photoelectric sensors, resistive edge sensors, and pulsed edge sensors. Only one monitored
entrapment protection device may
be wired to each input. Additional monitored entrapment protection devices may be wired to the expansion board.
NOTE: Board inputs for entrapment protection devices are yellow.
Control Board
CLOSE EYES/INTERRUPT
(2 Terminals) The CLOSE EYES/INTERRUPT input is for photoelectric
sensor entrapment protection for the close direction. When an
obstruction is sensed during gate closing the gate will open to the full
open position and resets the Timer-to-Close. This input will be
disregarded during gate opening.
CLOSE EDGE
(2 Terminals) The CLOSE EDGE input is for edge sensor entrapment
protection for the close direction. When an obstruction is sensed during
gate closing the gate will reverse to the full open position, disengaging
the Timer-to-Close. This input will be disregarded during gate opening.
OPEN EYES/EDGE
(2 Terminals) The OPEN EYES/EDGE input is for photoelectric sensor or
edge sensor entrapment protection for the open direction. When an
obstruction is sensed during gate opening the gate will reverse for 4
seconds then stop. This input will be disregarded during gate closing.
Close Photoelectric Sensors
Open Photoelectric Sensors OR Open Edge
Close Edge
Expansion Board
EYE ONLY and COM
Open or Close Direction Photoelectric Sensors, the functionality is based
on the switch settings (located next to the terminals)
Switch set to CLOSE: gate reverses fully when an obstruction is sensed
Switch set to OPEN: gate reverses 4 seconds when an obstruction is
sensed
EYE/EDGE and COM
Open or Close Direction Photoelectric Sensors or Edge Sensor, the
functionality is based on the switch settings (located next to the
terminals)
Switch set to CLOSE: gate reverses fully when an obstruction is sensed
Switch set to OPEN: gate reverses 4 seconds when an obstruction is
sensed
WIRELESS EDGE
Connection for wireless edge receiver. NOTE: ONLY one wireless edge
receiver may be connected to an operator. Up to 4 wireless edge
transmitters LMWETXU may be programmed to the receiver.
Photoelectric Sensors
Wireless Edge Receiver
Photoelectric
Sensors
OR
Edge
Sensor
INSTALLATION
Loading ...
Loading ...
Loading ...