Loading ...
Loading ...
Loading ...
24
Treadmill
CT800
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key
is pressed for example. To enter the Engineering Mode Menu press and hold down the Start,
Stop and Enter keys, then insert the safety key. Keep holding the keys down until the Message
Center displays Engineering Mode Menu. Press the Enter button to access the menu below:
a. Key Test (Will allow you to test all the keys to make sure they are functioning)
b. Security (Allows the keypad to be locked to prevent unauthorized use)
c. Functions (Press Enter to access settings and Up arrow to scroll)
i. Sleep Mode (Turn on to have the console power down automatically after 20 minutes of inactivity)
ii. Beep (Turns off the speaker so no beeping sound is heard)
iii. Grade Return - Returns the elevation to lowest setting when pause is pressedUnits (Sets the display to
readout in English or Metric display measurements)
iv. Units (Set to English or Metric display readings)
v. Maintenance (Resets the lube reset message and odometer)
vi. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indenitely)
d. Display Test (Tests all the display functions)
Calibration Procedure
1. Remove the safety key
2. Press and hold down the Start and Fast + buttons and replace the safety key.
Continue to hold the Start and Fast key until the window displays “Factory settings”, then press the
Enter key.
3. You will now be able to set the display to show Metric or English settings (Miles vs.
Kilometers). To do this, press the up or down key to show which you want, then press Enter.
4. Make sure the wheel size diameter is 2.98 then press Enter
5. Adjust the minimum speed (if needed) to 0.5 and then press Enter
6. Adjust the maximum speed (if needed) to 12.0 and then press Enter
7. Adjust the maximum elevation (if needed) to 15 and then press Enter
8. Grade return – On (This allows the incline to return to zero when Stop is pressed. For sale in Europe,
EU standards require this to be off)
9. Press Start to begin calibration. The process is automatic; the speed will start up
without warning, so do not stand on the belt.
Adjusting The Speed Sensor
If the calibration does not pass you may need to check the speed sensor alignment.
1. Remove the motor cover hood by loosening the 8 screws that hold it
in place. Set it aside.
2. The speed sensor is located on the left side of the frame, right next to the
front roller pulley (the pulley will have a belt around it that also goes to the
motor). The speed sensor is a small rectangular shaped black box with a
wire connected to it.
3. You will see a magnet on the outside edge of the pulley; make sure the
speed sensor is aligned with the center of the magnet when it passes by.
There are two a screws that hold the sensor in place that need to be
loosened to adjust the sensor. Re-tighten the screws when nished.
Engineering Mode Menu
Loading ...
Loading ...