Kenmore 79093761000 range

Use & Care Guide - Page 16

For 79093761000.

PDF File Manual, 20 pages, Read Online | Download pdf file

79093761000 photo
Loading ...
Loading ...
Loading ...
General Cleaning
(continued)
The dooris heavy. For
safe, temporary storage, lay the door
flat with the inside of the doorfacing
down.
To Remove and Replace Oven Door
To Remove Oven Door:
1. Open the door.
2. Remove screws located on the insideofthe oven door near the hinges A
(one on each side.)
3. Close the door tothe quarter-open position. Grasp the door firmlyon both
sides and liftup and offthe hinges.
4. To clean oven door,followthe instructionsprovided inthe cleaningchart
underGeneral Cleaning
Uft door straight off 2 door hinges
-A
Figure 1
Figure 2
To Replace Oven Door:
1. Be sure the hinge arms are inthe quarter-open position. Be careful if
pullingthe hinges open byhand. The hinges may snap back against the
oven frame and could pinchfingers.
2. Hold the door at the sides near the top, Insertthe hinge arms intoslots at
the bottom of the door,
3. Hinge armsmustgo intothe range slots evenly.The hinge arms should
be inserted intothe bottom corners ofthe door as far as they can go,
4. If the door isnot in linewith the oven frame, remove itand repeat the
above steps,
To Remove and Replace Warmer Drawer (if equipped)
To Remove Warmer Drawer:
1. !r_P4_l'j"_1_ Turn power offbefore removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. On the right glide you will find a shield attached with a hex-head screw
(see figure 1). Using a 1/4" socketand ratchet remove the shield.
4. Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1. Replace shield on the rightglide of the drawer body.
2, Pull the bearing glides to the front of thechassis glide (see figure 2).
3. Alignthe glideon each side of the drawer withthe glide slots on the
range.
4. Push the drawer intothe range untillevers "click" (approximately2"). Pull
the drawer openagain to seat bearing glides intoposition, If you do not
hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 2-4. Thiswill minimize possible
damage to thebearing glides.
_!Vlvf_,l:lOll_[Cll Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
16
Loading ...
Loading ...
Loading ...