Loading ...
Loading ...
Loading ...
General Cleaning
(continued)
Be sure the range is
cool before removing elements or drip
bowls. Be careful not to bend terminal
ends when replacing elements after
cleaning.
Allow Element
Plug
Main Top
I1_ When lowering the lift-
up range top, grasp the sides with
finger-tips only. Be careful not to pinch
fingers. DO NOT drop or bend the
range top when raising or lowering.
This could damage the surface,
Surface Elements and Drip Bowls
Surface elements can be unplugged and removed to make cleaning the drip
pans easier. The surface elements clean themselves when they are turned
on, Food spilled on a hot element will burn off. Food spilled on a cool element
may be cleaned with a damp cloth--any remaining soilwill burn off the next
time the element is used.
Never immerse a surface element in water.
To Remove the Surface Elements and Drip Bowls
1. Lift the edge of the drip bow! across from the terminal end. Lift the
surface element and drip bowl together just enoughto clear the
cooktop.
2. While holding the drip bowl and surface element, gently pull the terminal
end out from the terminal plug. If equipped, DO NOT remove the hold
down clip from the drip bowl.
To Clean Drip Bowls
Wash in hot, soapy water or in the dishwasher. Rinse and dry while stillwarm. I'TI
Hard to remove, burned on soil can be removed bysoakingthe dripbowlsfor Z
about 20 minutesin a lightlydiluted liquidcleanser ora solutionof ammonia
and water (1/2 cup ammonia to 1 gallon of water). A nylon scrubber may be r-
used after soaking. DO NOT use abrasive cleaners or steel wool, as they will
scratch the surface. Always rinse with clean water and polish dry with a soft "1"
cloth,
To Replace Drip Bowls and Surface Elements
1. Slide the terminal end on the element throughthe opening inthe drip
bowl.
2. Alignthe element supportto rest on the rim insidethe drip bowl. Ifyour
dripbowlis equipped with a hold downclip, alignthe element support
oppositethe terminal end with the slot inthe hold downclip, and snap into
place.
3. After the element is positionedinthe drip bowl, lineup the terminal end
withthe terminal plug as shown,
4. Hold the surface element and drip bowltogether as level as possibleand
firmlypush the terminal end into the terminal plug. Make sure element
terminal isseated properly intoterminal plug.Make surethe surface
element is level to reduce the hazard of pans slidingoffthe element.
To Raise the Top for Cleaning
1. Grasp the sides and lift from the front. Lift-uprodswillsupportthe top in
itsraised position.Only liftthe top highenoughto allowthe supportrods
to snap intoplace.
2. Clean underneath using a clean clothand hot,soapy water.
3. To lowerthe top, gently pushback on each rodto release the notched
support.Hold the range top and slide the range top down intothe range
frame.
15
Loading ...
Loading ...
Loading ...