Loading ...
Loading ...
Loading ...
STEP 2. Slide large end of the duct on
the dQ/er connection and the small end
on the hood connection. To prevent air
leakacle, tape the joint with duct tape.
Clamp all joints.
Tape
J
Continue Installation on This Page.
FINISH INSTALLATION/
CHECKPOINTS
Taking a few minutes to complete
this checklist will help ensure a
proper installation and increase your
satisfaction with your electric dryer.
[]
[]
[]
[]
[]
[]
[]
Check that all parts you removed
from the parts packages are now
installed.
Carefully slide dryer into its final
location.
Check to be sure dryer is level
by placing level on top of the dryer,
first side-to-side then front-to-back.
If dryer is not level, adjust the legs
up or down.
Check to make sure you have all
the tools you started with.
Plug the power supply cord into
the grounded outlet or connect direct
wire to power supply. Turn power
supply on.
Wipe the interior of the drum
thoroughly with a damp cloth to
remove any dust.
Read the rest of this manual to fully
understand your new dryer. Start the
dryer and allow it to complete a full
heat cycle. You may notice a burning
odor. This smell is common when
the heating element is first used. The
smell will go away. After five minutes,
open dryer door. You should feel heat
inside the dryer. If you do not feel
heat, see Troubleshooting information
on pages 25-26.
19
Loading ...
Loading ...
Loading ...