Bosch 4100-10 10 In. Worksite Table Saw with Gravity-Rise Wheeled Stand

Operating / Safety Instructions - Page 20

For 4100-10.

PDF File Manual, 144 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
20
Storage, Transportation, and Mounting
MOUNTING THE TABLE SAW
If table saw is to be used in a permanent lo-
cation, it should be fastened securely to a
firm supporting surface such as a stand or
workbench, using the four mounting holes 24
(Fig. 19).
1. If mounting to a workbench, the base
should be bolted securely using 5/16"
hex bolts (not included) through mount-
ing holes 24.
Hint: If workbench is 3/4” thick, bolts
will have to be at least 3-1/2” long - if
workbench is 1-1/2” thick, bolts should
be at least 4-1/2” long.
2. Locate and mark where the saw is to be
mounted, relative to holes in the base of
the tool.
3. Drill four (4) 3/8" diameter holes
through workbench.
4. Place table saw on workbench aligning
holes in base with holes drilled in work-
bench.
5. Insert four (4) 5/16" dia. bolts through
holes in base and supporting surface;
then secure with (4) 5/16” flat washers
and (4) 5/16" hex nuts.
24
5/16HEX BOLT,
WASHER AND
HEX NUT
X4
Adjusting Blade Parallel to the
Miter Gauge Slots
The blade was adjusted parallel to the miter
gauge slots at the factory. In order to ensure
accurate cuts and help prevent kickback, this
adjustment should be rechecked. If adjust-
ment is necessary, follow the steps below.
To prevent personal in-
jury, always dis con nect
the plug from power source before mak ing
any adjustments.
1. Turn elevation wheel and raise blade as
high as it will go.
2. Select a point on the body of the saw
blade that is set to the left when viewing
blade from the front of saw, and mark 1
with a pencil (Fig. 20).
3. Place the base of a combination square
against the edge of the miter gauge slot,
and extend the sliding rule of square so
it just touches the marked point 1 on
the body of the saw blade at the rear of
the table.
1
UNDER FRONT OF
TABLE
2
Adjustments
Fig. 19
Fig. 20
Fig. 21
2610048783.qxp_4100 11/17/17 9:10 AM Page 20
Loading ...
Loading ...
Loading ...