Loading ...
Loading ...
Loading ...
SMART GUARD SYSTEM STORAGE
When not in use, the Main Barrier Guard and
Anti-Kickback Device can be stored under the
right side table extension.
Use of all the components
of the Smart Guard Sys-
tem, including Main Barrier Guard, Anti-Kick-
back Device, and Riving Knife is highly
recommended to provide protection against
accidents and injury.
A. Slide the Main Barrier Guard assembly
19a (upside down) up and back into the
strap support 20b at the rear right side
of the saw (Fig. 17).
B. Pivot the rear of the guard up and into
the front mounting bracket 20a
(Fig. 17).
C. Lock the Main Barrier Guard assembly
19a into place in the same manner as
you would attach it to the Riving Knife
(Fig. 18).
D. Attach the Anti-Kickback Device 19b to
the hanging bracket in the same manner
that it attaches to the Riving Knife
(Fig. 18).
A
B
RIP FENCE AND PUSH STICK STORAGE
• When not in use, store rip fence 18 in
rip fence storage 11 on the right side
panel of the saw (Fig. 16).
• Mount the push stick 22 onto the push
stick holder 23 and slide as shown to
lock it in place (Fig. 16).
• Store the blade wrench 14 in its dedi-
cated area, secured with a wing nut
(Fig. 16).
• Wrap the power cord around the cord
wrap 16 (Fig. 16).
• Mount the 5mm hex wrench 15 in its
dedicated storage location on the right
side of the base (Fig. 16).
19
Storage, Transportation, and Mounting
23
22
1511 18
14
16
C
D
20a
19a
20b
19b
20a
19a
Fig. 16
Fig. 17
Fig. 18
2610048783.qxp_4100 11/17/17 9:10 AM Page 19
Loading ...
Loading ...
Loading ...