Loading ...
Loading ...
Loading ...
© 2020 United States Stove Company
23
WIRING DIAGRAM
WHEN USED AS A HEATING APPLIANCE
HEAT OUTPUT
When used as a ventless heater, ue damper of a
solid-fuel burning non-combustible replace must
always be closed. The heat output is controlled
by the “On/Off” switch or wall thermostat when
using Millivolt Valve. The Vent-Free replace may
be installed where permitted by local, state and
city codes. In the absence of local codes, the latest
edition of the National Fuel Gas Code (ANSI Z223.1)
must be met.
WARNING:
CHILDREN AND ADULTS SHOULD BE
ALERTED TO HAZARDS OF HIGH SURFACE
TEMPERATURES AND SHOULD STAY AWAY
TO AVOID BURNS OR CLOTHING IGNITION.
YOUNG CHILDREN SHOULD BE CAREFULLY
SUPERVISED WHEN THEY ARE IN SAME ROOM
WITH APPLIANCE
WARNING:
DO NOT PLACE CLOTHING OR OTHER
FLAMMABLE MATERIAL ON OR NEAR
APPLIANCE.
Note: If any of the original wire as supplied with the
gas appliance must be replaced, it must be replaced
with a wire of at least a 105ºC temperature rating.
Note: Installation and repair should be done by
a qualied service person. This heater should be
inspected before use and at least annually by a
qualied service person. More frequent cleaning
may be required due to excessive lint from carpeting,
bedding material, etc. It is imperative that control
compartments and circulating air passageways of
heater be kept clean.
CAUTION:
LABEL ALL WIRES PRIOR TO DISCONNECTION
WHEN SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION.
WARNING:
ELECTRICAL GROUNDING INSTRUCTION:
HEATER IS EQUIPPED WITH A THREE-PRONG
PLUG FOR YOUR PROTECTION AGAINST
SHOCK HAZARD AND SHOULD BE PLUGGED
DIRECTLY INTO A PROPERLY GROUNDED
THREE-PRONG RECEPTACLE.
Note: 80442 blower motor. Rating: 120 volts/60hz/1.1
Amps.
Note: for convenience, allow licensed electrician to
install properly grounded 3-plug receptacle near
unit.
Loading ...
Loading ...
Loading ...