Loading ...
Loading ...
Loading ...
16
© 2020 United States Stove Company
INSTALLATION
The Manufacturers Trim Kit must be used for Zero
Clearance Installation. See the “Insert Fireplace
Facade Installation” section of this manual for
replace installations.
GAS LINE
The gas supply line and electrical supply must
be installed before framing in the replace by a
licensed installer.
DRAFTS
Do not locate the replace in high trafc areas or
areas exposed to high drafts and winds. Locate the
replace away from furniture and draperies.
ROOM
DIVIDER
PARTIAL ROOM
PROJECTION
FULL ROOM PROJECTI ON
FLUSH
C
ORNER
WARNING:
SOLID-FUELS SHALL NOT BE BURNED IN A
FIREPLACE IN WHICH AN UNVENTED ROOM
HEATER IS INSTALLED.
CAUTION:
ANY OUTSIDE AIR DUCTS AND/OR ASH DUMPS
IN THE FIREPLACE SHALL BE PERMANENTLY
CLOSED AT TIME OF APPLIANCE
INSTALLATION.
WARNING:
BEFORE INSTALLING IN A SOLID-FUEL
BURNING FIREPLACE, THE CHIMNEY FLUE
AND FIREBOX MUST BE CLEANED OF SOOT,
CREOSOTE, ASHES AND LOOSE PAINT BY A
QUALIFIED CHIMNEY CLEANER.
ZERO CLEARANCE STANDOFF(S)
ASSEMBLY
NOTE: All Standoff must be attached to the
appliance before installing as a Zero Clearance
appliance.
Follow the instructions given in the diagrams below
exactly.
NOTE: If installing with the mantel kit refer to the
instructions included with the mantel kit for correct
installation.
Back Standoff located 7”
from the top of the
rear of the appliance,
and center left to right.
Top Standoff
(2 per unit)
Side Standof
f
(2 per unit)
6-5/8”
2”
7”
Side Standoff
35-/9/16” OPENING FOR
UNIT
13-3/4” MIN.
1.5”
7” FROM
OPENING
TO WALL.
Rear-Standoff
Top Trim PanelTop-Standoffs
FIREPLACE CLEARANCES (ZC)
The stove may be placed directly on a combustible
oor, against a combustible wall at marked
clearances or on a raised wooden platform. If
the stove is to be installed on a raised wooden
platform, the platform must be a continuous level
surface. The replace must be secured in place so
it cannot shift positions. Only header (see below)
Loading ...
Loading ...
Loading ...