Loading ...
Loading ...
Loading ...
18
Be sure the range is unplugged and all parts
are COOL before replacing oven light. Wear a leath-
er-faced glove for protection against possible broken glass.
To replace oven light:
1. Turn electrical power o at
the main source or unplug
the range.
2. Replace bulb with a new 40
watt appliance bulb.
3. Turn power back on again
at the main source (or plug
the range back in).
4. The clock will then need
to be reset. To reset see
“Setting clock”.
Care & Cleaning
Relacing oven light (some models)
Oven
light
To raise and lower the cooktop:
1. Remove all items from cooktop and set aside.
2. Grasp the sides of the cooktop and then lift from the
front (See Fig. 1).
3. Lift the cookop high enough to allow the support rods
to snap into place. The lift-up rods will support the
cooktop in the raised position.
4. If necessary, clean underneath using hot, soapy water
and a clean cloth; then dry.
5. To lower the cooktop, grasp the front corner of each
side of the top while pushing back on each rod with the
heel of your hand. This will release the notched support.
Hold the range cooktop and gently slide the top back
down level to the range.
To avoid possible burns DO NOT turn the
surface elements on when the cooktop is raised. Be sure
that the top is completely lowered and securely in place
before turning on any of the surface burners.
cooktop
lift-up rods
When lowering the lift-up range cooktop,
grasp the sides with ngertips only. Be careful not to
pinch ngers. Do not drop or bend the cooktop when
raising or lowering. This may permanently damage the
cooktop surface.
Raising and lowering the cooktop (some
models)
Aluminum foil and utensils
NEVER cover any slots, holes or passages
in the oven bottom or cover an entire oven rack with ma-
terials such as aluminum foil. Aluminum foil linings may
trap heat, causing a re hazard.
Protective liners — DO NOT USE
ALUMINUM FOIL to line the oven bottom. — DO NOT USE
aluminum foil to line surface drip bowls, or reector pans.
Only use aluminum foil as recommended in this manual.
Improper installation of these liners may result in risk of
electric shock, or re.
Fig. 1
Loading ...
Loading ...
Loading ...