Loading ...
Loading ...
Loading ...
ASSEMBLY
Assembly requires two people. Set thetreadmillin a cleared area and remove all packingmaterials.Do not
dispose ofthe packing materialsuntilassemblyis completed.Assembly requires the included allen wrenc_
and your own phillips screwdriver _ and wire cutters _.
Note: The undersideof the treadmill walkingbelt iscoated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (69) until the treadmill is in the position shown.
Refer to the inset drawing. Insert one ofthe Extension
Legs (102) into the treadmill as shown. Make sure that
the Extension Leg is turned so the Base Pad (99) is on
the bottom. Note: It may be helpful to tip the Uprights
(69) forward as you insertthe Extension Leg.
Insert the otherExtensionLeg (not shown) inthe same
way.
2. Press the Lock Knob Sleeve (70) into the left Upright (69).
Remove the LockKnob (68) from the Lock Pin (74). Make
sure that the Lock Pin Collar (72) and the Spring (71) are
on the Lock Pin.
Insert the Lock Pin (74) into the Lock Knob Sleeve (70)
and the left Upright (69). Press the Lock Knob Spacer
(35) onto the left Upright.
Tighten the Lock Knob (68) back onto the Lock Pin (74).
35
70
71
72
74
3. With the help of a second person, carefullytip the
Uprights (69) down as shown. Make sure that the
Extension Legs (102) remain in the Uprights.
Attach each ExtensionLeg (102) with two 3/4" Screws
(100) as shown.
With the help of a second person, carefullytipthe
Uprights(69) backto the verticalposition.
Note: One replacement Base Pad (99) may be included.
Use the Base Pad to replace any Base Pad that becomes
worn.
69
99-
""_102
102
6
Loading ...
Loading ...
Loading ...