Loading ...
Loading ...
Loading ...
Operating Sony Components
2 While holding down the button corresponding to
the component, press down the function button
whose setting isto be changed (the AUX function
button, for example).
The AUX function button is now set to control the
Sony LD playen
To reset a button to its factory setting
Repeat the procedure above.
To reset all function buttons to their factory
settings
Press down I/V, AV I/_ and MASTER VOLUME -
simultaneously, or uninstall the batteries once and press
any key, then install them again.
Operating Non-Sony
Components
You can program the remote to control non-Sony
components. Once the control signals have been
memorized, you can use those components as part of your
system.
Note, however, that the settings of the DVD and TUNER
function buttons cannot be changed.
SET
Enter
0
:r
Q
0
f_
5"
1 Press IR SET.
2
Pressthe function button for the component you
want to control.
For example, if you are going to control an LD player,
press AUX.
The function button lights up.
3
Pressthe number buttons to enter the numeric
code (or one of the codes if more than one code
exist) corresponding to the component and the
make of the component you want to control.
See the tables on pages 61 and 62 for information on
the numeric code(s) corresponding to the component
and the make of the component,
4 PressENTER.
When the function button goes off, the component(s)
can then be controlled using this remote.
5 Repeat Steps 1 to 4 to control other components.
• If the function button flashes three times consecutively, the
programming has failed. Check that the numeric codes
corresponding to the component and the make of the
component are correct. Start again from Step 1.
• If you do not do Step 2 within twenty seconds after pressing
the IR SET button ti_ Step 1, the remote automatically exits
learning mode. Start again from Step 1.
6O
Loading ...
Loading ...
Loading ...