Loading ...
Loading ...
Loading ...
18
TROUBLESHOOTING
If any irregularities occur during normal operations, E: XX will display on the control panel. This
will be displayed until the machine is switched off. Try the suggestions below to see if you can
solve the problem.
Problem/
Error
Indication on the display unit and
problem description
What to do?
E0
Incorrect settings
Restart the program. If the error occurs
again, call a service technician.
E1
Temperature sensor error
Inlet water too cold. Repeat the
washing program.
If the washing machine reports this
error again, call a service technician.
E2
Door lock error
Make sure the washing machine door is
closed. Unplug the power cord from the
outlet. Plug the power cord back into the
outlet, and turn on the washing machine.
If the error occurs again, call a service
technician.
E3
Water filling error
Check the following:
• Is the water inlet valve open?
• Is the filter on the water supply hose
clean?
• Is the water supply hose deformed
(clipped, clogged etc.)?
• Is the pressure in the water mains
between 0.05 and 0.8 MPa (7.25-
116psi)?
Then, press the (3) START/PAUSE
button to resume the program. If the
error reoccurs, call a service technician.
E6
Water heating error
Restart the program. If the error
reoccurs, call a service technician.
E7
Water draining error
Check the following:
• Is the pump filter clean?
• Is the discharge hose clogged?
• Is the drain clogged?
• Is the discharge hose is placed
between the maximum and the
minimum height (see the
INSTALLATION AND
CONNECTION/ Connecting and
securing the water discharge hose
section).
Then, press the (3) START/PAUSE
button again. If the error reoccurs, call
a service technician.
Loading ...
Loading ...
Loading ...