Loading ...
Loading ...
Loading ...
Table1Minimumgaugeforextension
cords
Volts
120V
240V
Ampererating
morethannot
morethan
0-6
6-10
10-12
12-16
Totallengthofcordin
feet
25 50 100 150
50 100 200 300
AWG
|
18 16 16 I 12
18 16 14 I 12
16 16 14 12
Not
14 12 recom-
mended
i\lo'rl_: Only the applicable parts of the
Table need to be included. For instance, a
120-volt product need not include the240-
volt heading.
Figure I
-- METHOD OF SECURING EXTENSION
CORD
CORD APPLIANCE CORD
(A)TIE CORD AS SHOWN
(B) CONNECT PLUG AND RECEPTACLE
ABI)ITIONAL S&FE
INS'fRIIC'I'IONS
_ WARN|NO: Do Bet ove{{each.
WARNiNG: Do not use this tool to
fell trees
o Pre-plan a safe exit from falling branches
and debris. Ensure the exit route is clear
of obstacles that would prevent or hinder
movement. Remember freshly cut bark and
wet grass is slippery.
o Be aware of the direction that a branch may
fall. Consider all conditions that may affect
the direction of fall. Including:
* The intended direction of fall
* The natural lean ofthe branch
o Any unusual heavy limb structure
or decay
o Surrounding trees and obstacles
including overhead power lines.
* The wind speed and direction.
* The safe distance between a branch and
debris to be trimmed and bystanders,
buildings, and other objects is at least
21/2 times the length of the branch. Any
bystander, building, or object within this
distance is at risk from being struck by the
falling branch.
* When cutting a limb that is under tension
be aware of spring back. When tension
in the wood fibres is released the spring
loaded limb may strike the operator and/or
throw the tool out of control.
* Always wear suitable safety equipment
such as no-skid heavy-duty shoes, goggles,
ear protection, face shield, and gloves
when operating this tool.
* Ensure someone is nearby (at a safe
distance) in case of an accident.
* Do not attempt to operate this tool when
in a tree, on a ladder, or standing on other
unstable support.
* Keep proper footing and balance at all
times.
* Keep handles dry, clean, and free from oil
and grease.
* Do not let the moving chain contact any
object at the tip of the guide bar.
* Begin and continue cutting only with the
Loading ...
Loading ...
Loading ...