Loading ...
Loading ...
Loading ...
Problem solving guide
50
Problem Possible cause and remedy
and flash again
after a programme
cancellation, despite
thorough cleaning.
The plinth filter looks clean after thorough cleaning.
However, the programme is terminated again and the
error message appears again. There are probably still
deeper residues which could not be removed.
To switch off : Switch the tumble dryer off
and back on.
Check all of the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
in "Problem solving guide - Checking the heat
exchanger".
The plinth filter is clogged on a deeper level.
Check the plinth filter. Follow the instructions in
"Problem solving guide - Replacing the plinth
filter".
If the plinth filter is not deformed or defective, you
can regenerate it in the washing machine. Follow
the instructions in "Problem solving guide -
Regenerating the plinth filter".
lights up after a
programme has been
cancelled and a signal
sounds.
The condensed water container is full or there is a
kink in the drain hose.
Empty the condensed water container.
Check the drain hose.
See “Cleaning and care”.
To switch off :
Open and close the door (with the dryer switched
on).
lights up. The programme selector has been moved.
Select the original programme. The time remaining
will appear in the display again.
Bars flash in the display
at the end of a
programme:
.........
The programme has finished but the laundry has not
yet cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Loading ...
Loading ...
Loading ...