Loading ...
Loading ...
Loading ...
CLIE/a, I @WEI
DISCONNECT SPARK PLUG WIRE TO
PREVENT ACCIDENTAL STARTING BE-
FORE CLEANING,
Water pressure from d garden hose witt remove fresh clippings
from underside of mower Clean mower, top and underside,
after each mowing,
BELT REPLACEMENT
MAIN DRDVE BELT
1 Remove mower from tractor, refer to _'To Remove
Mower, page 20
2, Remove Bait Guard from Drive Sheave by removing Nuts
and Washers from Clutch Arm Pivot and Drive Sheave
(Figo 41).
3, Loosen Bolt in Flat ]diet and Drive Idler Arm (Fig 41)
4, Remove Belt,
5 To replace Belt reverse steps 1 thru 4
DECK DRBVE BELT
t Remove mower from tractor_ Refer to "To Remove
Mower, page 20,
2 Remove Belt Guard from Drive Sheave by removing Nuts
and Washers from Clutch Arm Pivot and Drive Sheave
{Fig. 41).
3 Remove Lower Clutch Rod from Clutch Bell Crank (Fig.
42L
4 Remove Belt from L.H Mandre! as follows:
a,. Place a Flat Washer on end of Lower Clutch Rod and
secure with a Retainer Spring (Use one of the Washers
and Retainer Springs that mounted mower to tractor)
(Fig. 43),
b Place Lower Clutch Rod over Idler Arm and back of
Spring. Have Washer under Idler Arm (Fig, 48)
c, Pull on Rod to loosen Belt so that it can be removed
from L.H. Mandrel (Fig. 43).
5 Remove Clutch Bracket Strut (Fig 44)
6,, Loosen front bolt in R,H Clutch Bracket (Fig. 44}
7. Remove rear bolt from R.H. Clutch Bracket (Fig, 44)
8 Remove Clutch Arm Pivot Boft from Clutch Arm and
L,H Bracket (Fig. 41)
9 Raise rear of RH Clutch Bracket and slip Belt to the out-
side (Fig, 44)
I0o Continue by slipping Belt between Deck Drive Idler and
Drlve idler Arm (Fig 44) Remove Belt from bottom
groove of Drive Sheave and then from mower (Fig, 44),
11_ Tighten all bolts sucurety and spread cotters before re-
placing mower on tractor.
12 To replace, reverse steps 2 thru 10, NOTE: LEAVE BOLTS
IN RH. CLUTCH BRACKET LOOSE UNTIL THE
CLUTCH BRACKET STRUT IS iN PLACEr
11Q =
Loading ...