Loading ...
Loading ...
Loading ...
EN
W415-2349 / A / 10.31.19
41
fi nishing
6.0 optional blower installation
A. Ensure that the access cover plate has been
installed. For location, see "switch and bracket
installation" section.
B. Remove the on/off switch bracket and the
cover plate below it. The switch spacers and
cover plate may now be discarded.
C. Decide which side of the blower housing you
prefer the on/off switch to be located on.
D. Remove the top 2 screws from the left outer
edge of the rear appliance panel.
E. Mount and secure the blower housing using 4
screws (two of which were removed in previous
step). Ensure that the on/off switch wires pass
through the appropriate slot located on either
side of the blower housing.
F. Remove the 2 screws from the side of the
blower housing that you want the switch to be located on
and re-secure the on/off switch.
Because the blower is thermally activated, when turned on,
it will automatically start approximately 15-30 minutes after
lighting the appliance and will run for approximately 30-45
minutes after the appliance has been turned off. Use of the
fan increases the output of heat.
Drywall dust will penetrate into blower bearings causing ir-
reparable damage and must be prevented from coming into
contact with the blower or its compartment.
Any damage resulting from this condition is not covered by
the warranty policy.
SLOT
REMOVED SCREWS
Loading ...
Loading ...
Loading ...