Loading ...
Loading ...
3
IM PORTANT INSTRUCTIONS
Read all instructions before inst alling or using this heater.
2. Keep combustible mat erials, such as furnit ure, pillows, bedding, papers, clothes and curt ains at
least 3 feet from the front of the heater; keep them away from sides and rear as well.
3. Always unplug heater when it’s not in use.
4. Do not operat e the fireplace if it has a damaged cord or plug, after it has malfunctioned, or if the
unit has been dropped or damaged in any way.
5. Do not use the heat er outdoors.
6. This heat er is not intended for use in bathrooms, laundry areas and similar indoor locations.
Never place the heater where it may fall into a batht ub or other wat er containers.
7. Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners or anyt hing
else. Arrange the cord away from traffic areas where it could not be tripped over.
8. To disconnect the heater, turn the controls to "OFF" before removing the plug from the out let.
9. Do not insert or allow foreign objects to ent er any ventilat ion or exhaust opening, as this may
cause an electric shock, fire or damage to the heater.
10. To prevent a possible fire, do not block air int akes in any manner.
11. A heat er has hot and arcing or sparking part s inside. Do not use it in areas where gasoline, paint
or flammable liquids are used or st ored.
12. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or injury to persons.
13. Avoid the use of an extension cord because the ext ension cord may overheat and cause a fire.
14. Always use properly grounded fused and polarized out let s.
15. Always use ground fault prot ection where it is required by electrical codes.
16. Always disconnect the pow er before performing any cleaning, maintenance or relocation of the
heater.
17. To prevent a possible fire, do not burn wood or other mat erials in this heater.
18. To prevent electric shock or fire, always use a certified electrician, should new circuit s or out let s
be required.
When transporting or st oring the heater, keep it in a dry place, free from excessive vibrat ion.
1.
19.
Loading ...
Loading ...
Loading ...