Loading ...
Loading ...
Loading ...
21
TRUBLE SHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Dim or no flame Flame LED’s are burnt out Inspect the LED’s and replace them if
necessary.
Ember bed is not
glowing or dimming
Ember LED’s are burnt out Inspect the ember bed LED’s and
replace them if necessary.
Appliance has overheated and
safety device has caused the
thermal sw itch to disconnect
Turn off the main swit ch, allow
appliance to cool for 10 minutes, then
turn it on.
House circuit breaker has
tripped
Reset house circuit breaker.
Appliance turns off and
will not turn on
Appliance’s fuse has blow n Replace the fuse.
Appliance is not plugged into an
electrical out let
Check plug and plug in.
Appliance has overheated and
safety device has caused the
thermal sw itch to disconnect
Turn off the main swit ch, allow
appliance to cool for 10 minutes, then
turn it on.
Appliance will not come
on when swit ch is
flipped to ON
Circuit board is burnt out Inspect the circuit board and replace
it if necessary.
No warm air coming out
of appliance
Heat er is burnt out Inspect the burner and heater
assembly and replace it if necessary.
Flame sputters
Flame motor is defective. Call a qualified service technician and
replace flame motor.
Remot e Control does
not work.
Low batt eries.
Unit sw itch in “O” position.
Replace AAA batt eries in remote
control.
Turn the swit ch in “I” position.
Flame is fixed. Wiring may be loose or the
flame mot or may be defective.
Loading ...
Loading ...