Loading ...
Loading ...
Loading ...
removing and installing bmades
WARNING: TO AVOID INJURY FROM ACCIDENTAL
STARTING, ALWAYS TURN SWITCH "OFF" AND
REMOVE SWITCH KEY BEFORE REMOVING OR
REPLACING THE BLADE.
1_ Loosen tension on blade by turning tension knob counter-
clockwise _ about two full turns.
Slight Pressure Here
2_
Remove blade by pulling forward on blade and then lifting
the blade through the access hole in the table.
Slight downward pressure against the upper arm may be
helpful when removing blade from upper holder.
3, Look atthe blade holders closely and noticethe blade slots
and pin recesses inthe blade holder. The blade holder is
made so you can position the blade for cutting from the
front or one side of the saw.
Cutting from the side ofthe sawwilt be necessarywhen your
work piece exceeds !6 inches in length. For zero degree
bevel angle only.
9
Loading ...
Loading ...
Loading ...