Loading ...
Loading ...
Loading ...
31-2001053 Rev. 0 29
Installation
PRE-TEST CHECKLIST
OPERATION CHECKLIST
Remove all protective film, if present.
Check to be sure that all wiring is secure and not
pinched.
Remove cooking deck shipping supports by:
1. Remove Shipping Support Dowel by pulling up
on one end.
2. Remove both Shipping Support Shoes, Slide out
from wall towards center of Stone.
3. Pull out from oven and discard.
IMPORTANT
• Remove all items from the inside of the oven.
• Check that conduit is securely connected to the
junction box.
• Turn on the power to the oven. (Refer to your Owner’s
Manual.) Verify that all cooking functions operate
properly.
• Check that the circuit breaker is not tripped nor the
house fuse blown.
• See your Owner’s Manual for troubleshooting list.
NOTE TO ELECTRICIAN: The power leads supplied
with this appliance are UL recognized for connections
to larger gauge household wiring. The insulation of
these leads is rated at temperatures much higher
than the temperature rating of household wiring. The
current carrying capacity of a conductor is governed
by the wire gauge and also the temperature rating of
the insulation around the wire.
NOTE: ALUMINUM WIRING
A.
WARNING
IMPROPER CONNECTION OF
ALUMINUM HOUSE WIRING TO THE COPPER
LEADS CAN RESULT IN AN ELECTRICAL
HAZARD OR FIRE.
B. Splice copper wires to aluminum wiring using
special connectors designed and UL approved
for joining copper to aluminum, and follow
the manufacturer’s recommended connector
procedure closely.
NOTE: Wire used, location and enclosure of
splices, etc., must conform to good wiring
practice and local codes.
Shipping
Support
Shoes
Loading ...
Loading ...
Loading ...