Loading ...
Loading ...
Loading ...
9
732 South Racetrack Road, Henderson, Nevada 89015
info@vinotemp.com
Start Using Your Refrigerator
You ought to get a good knowledge of all safety precautions and make sure that your
refrigerator has been placed properly in its final position before using.
1. Unpacking
Please install the decorative cover for bottom beam onto your refrigerator after unpacking and
adjust the front leveling legs to level your refrigerator.
2. Connecting Your Refrigerator to the Power Supply
Your refrigerator will enter the ex-factory default state after connecting to the power supply and
it will display target temperature for the refrigerator compartment and freezer compartment.
3. Work Modes of Your Refrigerator
You can set your refrigerator in either of the following two ways:
Auto mode: we suggest you choosing this mode if you have no special requirements.
Your refrigerator will work automatically after you chose this mode.
Manual mode: You can set the temperature by pressing the temperature adjustment key.
4. Put Food into Your Refrigerator
You can put your food into the refrigerator after a period of time (About hours in summer) when
the refrigerator has already fully refrigerated its interior compartments.
Tips: The interior temperature may require a certain period of time to reach balance if the setting temperature is
changed or other food is put into the refrigerator. Such a period of time depends on the change to the setting
temperature, the surrounding temperature, opening frequency, the amount of the stored food and etc.
Refrigerator compartment
Though the temperature-adjustable device could keep most of the refrigerator compartment at
an average temperature around 1℃~7℃, it fails to preserve the freshness of food for long. As a
result, the refrigerator compartment can be used only for short-term storage.
Use of turnover beam
Please keep strictly to the warnings on the label of the
turnover beam. It is a normal phenomenon that the
surface of the turnover beam is hot. Dews on the
surface are also normal in summer or when the
surrounding environment is wet. What you need to do is
to clean them away with cloth.
Adjustment of cantilever rack
The cantilever rack could be adjusted to the proper
height as required by food. Please adjust the cantilever
rack by following the arrows as shown in the diagram.
Raise it upward first and then take it out by tilting it
upward. During installation, put the upper end of the
fixed leg into one of the upper slots on the supporting
iron first and then put the lower end of the fixed leg into
the third slot on the lower part of the supporting iron.
Loading ...
Loading ...
Loading ...