Loading ...
Loading ...
Loading ...
8
WWW.VINOTEMP.COM
!
!
INSTALLATION
Remove all packaging material before using the new refrigerator. This includes the foam base and
all adhesive tape holding the refrigerator accessories inside and outside.
Clean both the inside and outside of the refrigerator with wet cloth (a little detergent could be added
into the warm water to wash the cloth and then wipe it again with the clean water).
Prepare an independent two-pole socket with grounding contact for the refrigerator and it shall not
share a multi-purpose socket with other electrical appliances.
Do connect grounding wire! The grounding pole of the
socket shall be provided with a reliable grounding wire.
Open the refrigerator body and take out the accessory
(decorative cover for bottom beam) and the three screws
from the instruction packaging bag. Next, install them into
the bottom beam as shown by the schematic diagram on
the right.
The decorative cover for bottom beam is used as
ornament, so you can choose not to install it. It won't
affect the refrigerator's performance or conditions no
matter whether you install it or not.
Transport and placing of your refrigerator
Transport
Keep upright and avoid squeezing or vibration during transport. Avoid a slant angle over 45 degree
during handling.
Avoid the door or top cap from being under excessive stress when moving; otherwise, it may
become deformed.
Placing
Place your refrigerator in a well-ventilated place
and keep it from heat source and direct sunlight.
Don't place it in any humid or wet place so as to
avoid rust and weakening of insulation effect.
There shall be a space not less than 30cm from
the top of your refrigerator and not less than 10cm
from both sides or the back of the refrigerator to
the adjacent walls respectively. This requirement
is good for open and close of the door and also for
heat emission.
The refrigerator shall be placed on a flat and firm
ground (if not flat, you can use the leveling legs for
adjustment).
Keep your refrigerator standing
Don't connect your refrigerator to the power supply
immediately after it is placed vertically. You should
keep it standing for at least 6 hours before switching it on in order to ensure it running well.
Make sure the power wire is not pinned by the refrigerator or other objects so as to avoid accidents
arising from power wire faults. Please check the voltage scope of your refrigerator against the actual
power supply before switching it on.
Note:
The refrigerator must be disconnected from the
source of electrical supply before attempting the
installation of accessory.
Don't use mechanical equipment or other methods
to accelerate the defrosting process except the
means recommended by the manufacturer.
Don't use any electrical appliances in the food
storage compartments except the model
recommended by the manufacture.
The R134a refrigerant and cyclopentane foaming
material used in the refrigerator are inflammable.
All waste and discarded refrigerators shall be
placed away from naked fire and they are not
allowed to burn.
Warm Reminder: place foods into the drawer. Do
not place any foods after removing the drawer.
Loading ...
Loading ...
Loading ...