Loading ...
Loading ...
Loading ...
t. OUBLL SHOOTDNc
PROBLEM:
Probable Cause,_,- Possible Remedy
WILL NOT START OR HARD TO START
No gasoline in Fuel Tank
Choke not set properly
Throttle Control not set properly
Choked improperly, l!ooded Engine =,-
Didy Air Cleaner
Loose Spark Plug Wire
Spark Plug dirty or improper gap _"
Water in gasoline orold fuel
Improper Carburelor adjustment ,,e--
Clogged Fuel Tank
Fill tank with gasoline
Place Choke Control in "CHOKE" position
Place Throltle Control in "FAST" position
Move Choke control to "Run" position, Place throttle Control in
"FAST" position and pull Starter several times to clear out gas
Remove and clean or replace
Make sure Spark Plug Wire is seated properly on Spark Plug
Replace Spark Plug and adjust gap
Drain Fuel Tank and Carburetor, use fresh fuel and replace Spark
Plug
Make necessary adjustments
Remove and clean
ENGINE MISSES OR LACKS POWER
Engine overloaded _,-
Partially plugged Air Cleaner
Didy Air Screen
Spark Plug dirty, improper gap or wrong type
Oil in gasoline ,_
Improper Carburetor adjustment ,_
Clogged Fuel Tank
Poor compression ,_-
Set Depth Stake and Wheels for shallower tilling
Remove and clean or replace
Clean Air Screen
Replace Spark Plug and adjust gap
Drain and refill Gas Tank and Carburelor
Make necessary adjustments
Remove and clean
Major Engine overhaul
ENGINE OVERHEATS
Low oil level or dirty oil ,,_'
Dirly Air Screen
Dirty Engine
Partially Plugged Muffler
improper Carburetor adjustment _-
Add or change oil
Clean Air Screen
Clean Cylinder Fins, Air Screen and Muffler area
Remove and clean Muffler
Adjust Carburetor 1oricher position
EXCESSIVE BOUNCE AND DIFFICULT HANDLING
Wheels and Depth Stake incorrectly adjusted ,,_ Adjust Wheels and Depth Stake
Ground too dry and hard _- Moisten ground or wait for more favorable soil conditions
SOIL BALLS UP OR CLUMPS
Ground too wet ,_- Wait for more favorable soil conditions
ENGINE RUNS WELL BU'I TILLER WON'T MOVE
Tine Control not engaged _ Engage Tine Control
V-Bell not correctly adjusted _ Check V-Bell
ENGINE RUNS WELL BUT LABORS WHEN TILLING
Tilling loo deep _ Raise Depth Slake
Throt!le Control not properly adjusted _- Check rhroltle Conlro! setting
Carburetor not adjusted properly _,- Check Carburetor adjustment
21
Loading ...
Loading ...
Loading ...