Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
• EDGING - 9 - 5/8 INCH PATH (inner Tines off, ouler
Tines assembled on innermost shalt position). HoIes "A'
in Tines to holes "D" in Tine Shalt (Fig. 23) Use this ar-
rangement for edging and first cultivation of crops in 15
inch spaced rows
DISCONNECt SPARK PLUG WIRE
WHEN CHECKING TINE CONTROL
OPERATION.
Fo o -- Jo---6--_q
-OUTER TINE
FIGURE 23
• NARROW CULTIVATING - 12 - 1/2 INCH PATH (inner
Tines off, outer Tines assembled on middle shaft posi-
tion) Holes "A" in Tines to holes "E" in Tine Shaft (Fig
24) Use this arrangement for cultivating narrow rows
A
E
A
o O O o
'OUTER TINE
FIGURE 24
NOTE: OUTER TINES CAN BE REVERSED - TINES
TURNED OUTWARD WILL THROW DIRT OUTWARD
TINES TURNED INWARD WILL THROW DIRT INWARD.
FOR CULTIVATING SMALL CROPS, EDGING OR
HILLING, ALL YOU NEED "TOREMEMBER AS YOU RE-
ASSEMBLE TINES IS THAT WHEN LOOKING AT THE
RIGHT SIDE OF THE TILLER, "R"s STAMPED ONTINES
WILL BE VISIBLE, AND ON THE LEFT SIDE OF THE
TILLER, STAM PED"L"s WILL SHOW. SHARPENED TINE
EDGES WILL ROTATE FORWARD FROM ABOVE
TINE OPERATION CHECK
• With Tine Control in "OFF" (UP) position, Tine Conlrol
Lever should be against Tine Control Body (Fig 25) If
not, loosen Clip and pull Tine Control Cable up Retighten
Clip If adjustments are made, make sure Tines do not
rotate when Tine Control is in 'OFF" position See next
step
, Wilh Tine Control in 'OFF" (UP) position, push Tiller
Handles down so Tines clear the ground Pull Slader
Handle Tines should not rotate If they do, loosen Clip
and push Tine Control Cable down Retighten Clip and
test Readjust if necessary
• With Tine Control in "RUNNING" position, push Tiller
Handles down so Tines clear the ground Pull Starter
Handle - Tines should rotate lorward If lhey do not,
loosen Clip and pull Tine Control Cable up Retighten
Clip and test Readjust if necessary
TINE CONTROL BODY
"OFF" POSITION
TINE CONTROL
"RUNNING
POSITION
;ONTROL
CABLE
SPARK
PLUG
STARTER
HANDLE
FIGURE 25
17
Loading ...
Loading ...
Loading ...