Loading ...
Loading ...
Loading ...
OPERATION
FILL FUEL,TANK
• To fill Fuel Tank (Fig 10), use fresh, clean regular un-
leaded automotive gasoline Capaoily is about 2
quads
,A
FILL TO WITHIN 1/2 INCH OF TOP OF
FUEL TANK TO PREVENT SPILLS
AND TO ALLOW FOR FUEL EXPAN-
SION. IF GASOLINE IS ACCIDEN-
TALLY SPILLED, MOVE MACHINE
AWAY FROM AREA OF SPILL.
AVOID CREATING ANY SOURCE OF
IGNITION UNTIL, GASOLINE VAPORS
;'{AVE DISAPPEARED.
FUEL TANK
CAP
DEPTH STAKE J
"UP" POSITION
THROTILE
CONTROL
CAUTION:
FIGURE 10
EXPERIENCE INDICATES THAT ALCO-
HOL BLENDED FUELS (CALLED GASO-
HOL OR USING ETHANOL OR METHA-
NOL) CAN ATTRACT MOIS'RJRE WHICH
LEADS TO SEPARATION AND FORMA-
TION OF ACIDS DURING STORAGE
ACIDIC GAS CAN DAMAGE THE FUEL
SYSTEM OF AN ENGINE WHILE tN
STORAGE
TO AVOID ENGINE PROBLEMS, THE
FUEL SYSTEM SHOULD BE EMPTIED
BEFORE STORAGE FOR 30 DAYS OR
LONGER. DRAIN THE GAS TANK, START
THE ENGINE AND LET IT RUN UNTIL
THE FUEL LINES AND CARBURETOR
ARE EMPTY, USE FRESH FUEL NEXT
SEASON. SEE STORAGE INSTRUCTIONS
FOR ADDITIONAL INFORMATION
NEVER USE ENGINE OR CARBURETOR
CLEANER PRODUCTS IN THE FUEL
TANK OR PERMANENT DAMAGE MAY
OCCUR
TO START ENGINE
A EEP 'THE TINE CONTROL IN "OFF" /
POSITION WHEN STARTING ENGINE,
J
• Make sure Spark Plug Wire is properly connected(Fig
• Place Throttle Control in "FAST" position (Fig 6).
• Place Choke Conlrol in "CHOKE" position (Fig.ll if
the Engine is cold. A warm Engine may not require
choking to start
• Grasp Starter Handle with one hand and grasp the
Tililer Handle with other hand Pull Rope out slowly un-
til Engine reaches start of Compression Cycle (Rope
will pull slightly harder at this point)
• Pull Rope with a rapid, continuous full arm slroke.
Keep a firm grip on Starter Handle and let Rope re-
wind slowly Do not let Starter Handle snap back
against Starter
• When Engine starts, place Choke Control on Engine
halfway between "CHOKE" and "RUN" positions and
then to "RUN" position as Engine warms up
, Move Throttle Control halfway between "FAST" and
"STOP" position for a few minutes to warm up
NOTE: In order to idle smoothly, a new Engine may
require 3 to 5 minutes running time above slow idle
speed Idle speed has been adjusled to be correct after
this break-in period.
SPARK
PLUG
CHOKE
11
STARTER
HANDLE
FIGURE 11
BREAKING IN YOUR TELLER:
Breakqn your Bells, Pulleys and Tine Control before you
actua!ly begin tilling
• Start Engine tip Tines off ground by pressing Handles
down and engage Tine Control to stad Tne rotation
Allow Tines to rotale for five minu|es
• Check Tine Operation and adjusl itnecessary (page 17)
[,_ THE MUFFLER AND SURROUNDING
AREA BECOME HOT AFTER RUNNING
ENGINE.
Loading ...
Loading ...
Loading ...