Loading ...
Loading ...
Loading ...
trou le shootin
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE TROUBLE
SHOOTING YOUR SANDER.
TROUBLE
Motor will not run,
Machine slows down
when :sanding.
,,,,,,,, , i,,i,,
Sanding Belt runs
off pulleys,
Wood burns while
sanding.
PROBABLE CAUSE
1. Defective On-Off switch. 1,
Defective switch cord.
Defective switch box.
2. Burned out motor. 2,
1. Timing belt too tight, 1,
2, Applying too much pressure to 2,
workpiece,
t, Not tracking properly,
1. Sanding disc or belt is
glazed with sap,
REMEDY
Replace defec'iive parts be;_ore
using belt disc sander again.
Consult Sears Service. Any at-
tempt to repair this motor may
create a HAZARD unless repair is
done by a qualified service techni-
cian, Repair service is available at
your nearest Sears Store,
,, ,,, J .
Decrease belt tension, see
Assembly Section,
Ease up on pressure.
1. Adjust tracking, see Assembly
Section, "Replacing the Sanding
Belt -- Tensioning and Tracking"
i, ,,, ,, ,H , II ,,I
1. Replace disc or belt.
RECOMMEN DED ACCESSORIES
iTEM CAT, NO.
Miter Gauge ................................................ 9--24214
Sanding Belts and discs ...................... See Catalog
Leg Set ................................. 9-22244
The above recommended accessories are
current and were available at the time this
manuat was printed.
19
Loading ...
Loading ...
Loading ...