Loading ...
Loading ...
Loading ...
TABLE
WHENIN A:HORIZONTAL
a: Loosenthe lock:nut usinga 314-inch wrench.
b: Place a level on the abrasive belt table and
using a 3/44nch wrench, screw the stop bolt
in or out until the belt table is level.
c. Tighten the lock nut.
Arrow shows di=rectionof rotation
! J
SURFACE SANDING ON THE SANDING BELT
Hold the workpiece firmly with both hands,
keeping fingers away from the sanding belt.
Keep the end butted against the backstop and
move the work evenly across the sanding belt.
Use extra caution when sanding very thin pieces.
For sanding long pieces, remove the backstop.
Apply only: enough pressure to allow the sanding
belt to remove material.
BACKSTOP
\
\
\
BELT
STOP
WRENCH
WOBKPIECE
SANDINGBELT
,Ul i i i
iii ii i
END SANDING ON THE SANDING BELT
It is more convenient to sand the ends of long
workpieces with sanding belt in a vertical posi-
tion.
See "Basic Operation - Positioning Belt Table"
for adjusting the belt table, and see "Assembly -
Installing Table Assembly" for adjusting work-
table.
Move the work evenly across the sanding belt;
For accuracy, use a miter gauge (accessory).
ii ii ii ,, i
SANDING
BELT "_, _1/ BELT
TABLE
WORKTABLE
ASSEMBLY_ i
i i: WORKPtECE
Loading ...
Loading ...
Loading ...