Classic UGP-30CR Retro 30” Convection Gas Range

User Manual - Page 38

For UGP-30CR.

PDF File Manual, 52 pages, Read Online | Download pdf file

UGP-30CR photo
Loading ...
Loading ...
Loading ...
38
Cleaners and Cleaning Materials
Do not use harsh cleaners or degreasers on or around functional parts (valves, controls,
etc., or aluminum tubing). This will damage or drastically reduce the life of the part.
Use only a mild solution of soap and water on backguards, aluminum control panels
and painted surfaces. Never use harsh abrasives or cleaning powders that may scratch
or mar the surface. Make sure the cleaners and cleaning materials are suitable for use
on the area to be cleaned. Always keep cleaning materials in a safe place. Never use a
sharp metal scraper to clean glass, porcelain, or painted surfaces.
Repair Parts
When repair parts are needed, contact the dealer from whom the range was purchased.
In case your range was purchased from a source other than an appliance dealer, you
may prefer to contact the manufacturer at the address shown in this manual.
Moisture
During the initial heat-up of your range, the heat mixing with the cooler air in the oven
cavity may produce fogging of the door glass or a collection of water on the door.
To prevent this, open the oven door for the first few seconds of initial oven heat-up.
This will allow the moist air within the oven to escape, without the forming of visible
moisture on the range. The amount of moisture will depend upon the humidity of the
air and water content of the food being cooked. Fogging and even dripping water will
usually occur in geographic locations of high humidity.
BURNERS AND CAST-IRON GRIDS
These parts can be removed and cleaned with appropriate products.
After cleaning, the burners and their flame distributors must be well dried and
correctly replaced.
It is very important to check that the burner flame distributor and the cap has been
correctly positioned - failure to do so can cause serious problems.
In appliances with electric ignition keep the electrode clean so that the sparks always
strike.
Note: To avoid damage to the electric ignition do not use it when the burners are
not in place.
CARE AND MAINTENANCE
Loading ...
Loading ...
Loading ...