Loading ...
Loading ...
Loading ...
The CANCELIDRAIN pad
The CANCEL/DRAIN pad allows you to cancel a cycle, to clear the signal lights or to
make a new selection.
• Press CANCEL/DRAIN while the dish-
washer is washing to start a 2 minute drain.
(If the dishwasher has not been started or
is not washing, it will clear the display.)
• Press CANCEL!DRAIN again to stop the
drain.
• Press CANCEL!DRAIN again to start a
2 minute drain, if there is stilt water in the
dishwasher.
NOTE: A small amount of water remaining
in the dishwasher is normal. See page 27.
Control panel lock-out feature
This feature lets you lock-out the functionof the control pads (except to cancel or pause a
cycle that is running). When the controlpanel islocked-out, the dishwasher cannot be started
and a running cycle cannot be changed.
To use the lock-out feature
1. Press and hold the OPTIONS and DELAY
pads until the CLEAN signal light flashes.
2. Release the pads. The CLEAN signal light
will stop flashing.
To turn off the lock-out
feature
1. Press and hold the OPTIONS and DELAY
pads until the CLEAN signal lightturns on
and stays on.
2. Release the pads. The CLEAN signal light
willturn off.
PRESS YOU SEE
PRESS YOU SEE
Adjusting the beeping sound
Each time a control pad is pressed, a single =beef)" sound is made. A double beep means one
of the extra features was selected (such as control panel lock-out) or the wrong control pad
was pressed.
To turn off the beep
1. Press and hold the OPTIONS pad until the
CLEAN signal light flashes. PRESS YOU SEE
2. Release the pad. The CLEAN signal light
will turn off.
NOTE: A power failure will reset this feature.
You will have to repeat the above steps.
To turn the beep back on
1. Press and hold the OPTIONS pad untilthe
CLEAN signal light turns on and stays on.
2. Release the pad. The CLEAN signal light
will turn off.
PRESS YOU SEE
Loading ...
Loading ...
Loading ...