Loading ...
Loading ...
Loading ...
Electrode
m ======_
®
_t=========
.0.2-.03 in.
(0.60-0.80 ram)
Figure 20
\
®
Engine Pulley
4. Check that the spark plug washer is in good condition and
thread the spark plug in by hand to prevent cross-
threading.
5. After the spark plug is seated, tighten with a spark plug
wrench to compress the washer.
Replacing the Belt
To replace the belt:
1. Remove the belt cover by removing the five hex screws that
secure it to the frame.
Figure 22
Belt Off
To replace the belt follow these instructiona and refer to Fig. 22:
1. Push down on the idler puller.
2. Position the new belt on top of the auger pulley and under
the belt keeper.
3. Route the belt around the engine pulley
4. Push the belt over the bottom of the auger pulley.
5. Reinstall the belt cover.
Idler Pulley
Hex Screws
2.
Figure 21
Push down on the idler puller to release the old belt from
under the belt keeper. Remove the old belt by grasping it
from the bottom of the auger pulley and pulling outward.
15
Loading ...
Loading ...
Loading ...