Loading ...
Loading ...
Loading ...
General Cleaning
'continued)
The door is heavy. For
safe, temporary storage, lay the door
flat with the inside of the door facing
Iown.
Le_ Glide
Figure 1
Figure 2
To Remove and Replace Oven Door
To Remove Oven Door;
1. Open the door.
2. Remove screws locatedon the inside ofthe oven door near the hinges A
(one on each side.)
3. Close the doorto the quarter-open position. Grasp the door firmly on both
sides and liftup and offthe hinges.
4. To clean oven door,followthe instructionsprovided inthe cleaningchart
under General Cleaning
Uft door straight off 2 door hinges
J .A
To Replace Oven Door:
1. Be sure the hinge arms are in the quarter-open position.Be careful if
pullingthe hingesopen byhand. The hinges may snap back againstthe
oven frame and could pinch fingers.
2. Hold the doorat the sides near the top. Insertthe hinge arms intoslotsat
the bottom of the door.
3. Hinge arms mustgo intothe range slots evenly. The hinge arms should
be inserted intothe bottomcorners of the door as far as they can go.
4. Ifthe door isnot in linewith the oven frame, remove itand repeat the
above steps.
To Remove and Replace Warm & Ready Drawer (if equipped)
To Remove Warm & Ready Drawer;
1. r _ Turn poweroff before removingthe Warm & Ready drawer.
2. Open the drawer tothe fully opened position.
3. On the rightglide you willfind a shield attached with a hex-head screw
(see figure 1). Using a 1/4"socket and ratchet remove the shield.
4. Locate glide lever on each side of drawer, pullup on the leftglide lever
and push downon the right glide lever.
5. Pullthe drawer away from the range.
To Replace Warm & Ready Drawer:
1. Replace shield onthe rightglide of thedrawer body.
2. Pull the bearing glides to the front ofthe chassis glide (see figure 2).
3. Align the glide on each side ofthe drawer withthe glide slots on the
range.
4. Pushthe drawer intothe range until levers "click" (approximately2"). Pull
the drawer open againto seat bearing glides intoposition. If you do not
hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 2-4. This willminimize possible
damage to the bearing glides.
I"_l _ ElectricalShock Hazard can occurand resultin
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
Ill
r-
I
19
Loading ...
Loading ...
Loading ...